Onderwerp: 3COM 4226T restore / resetten

Wie weet hoe ik eenvoudig een 3com switch 4226T kan resetten.
Alle info mag / moet er namelijk uit zodat ik hem opniwu (via console kabel) kan instellen.
De 3com site is dusdanig traag dat ik hioer het atwoord sneller zal vinden (denk ik)

Alvast mijhn dank!

Ik meen dat er een resetknop/gaatje voorop/achterop zit, tenminste, dat is wat ik meende te hebben gezien op die van mij.

Hoi Wempel en rest,

helaas zit er geen reset knop op (zover ik kan vinden)

via console kabel is het volgens mij mogelijk om softwarematig de switch weer te herstellen naar zijn factory defaults, een reset dus

Cause: If you forget your password, for the admin user account, and have no other "Security" user accounts set up on your unit, you will no longer be able to perform important security management operations on that unit. The following Password Recovery allows you to define a new password for the admin account, even though you have forgotten the current one.

Fix: Should there be no Security level logins (including "Admin") available on the unit, you must use the password recovery method outlined below, to define a new password for the "admin" user account: NOTE: Password recovery can be enabled or disabled at any time through the CLI, by accessing the CLI and using the security > device > user > pwdRecover command. CAUTION: If you disable Password Recovery for a Switch and subsequently forget the password for the "admin" user account, you will have to return the Switch to 3Com. NOTE: If your product has a Redundant Power Supply (RPS) connected, you will need to disconnect it in order to perform a hard reset. NOTE: You cannot use a soft reset operation to reset the password of the "admin" user account. This will end the password recovery procedure and return you to the CLI login prompt. NOTE: Password recovery cannot be performed via a SLIP (Serial Line Internet Protocol) connection. Use the password recovery method outlined below to define a new password for the admin username:

1.Access the Command Line Interface and enter the user name "recover" and password "recover" to place your unit in password recovery mode. The unit will remain in password recovery mode for a maximum of 30 seconds, before it returns to the CLI login prompt.
2. During the 30 seconds, perform a hard reset on the unit while the it is still in password recovery mode by switching it off, waiting a few seconds, and switching it on again.
3. When the unit has rebooted following the hard reset enter a new password for the "admin" user account.
4. Enter enable to leave password recovery enabled, or enter disable to turn it off. You are now logged in as the default "admin" user. NOTE:Password recovery cannot be performed via a SLIP (Serial Line Internet Protocol) connection.

Dit heeft gewerkt op een 4226T bij me.