Wireless USRobotics not compatible with Belgacom?

[XYZ]

Hi all,
I bought a Wireless MAXg ADSL 9108 and a PC Card USR5411 to use for my
Belgacom connection. But have been having great difficulties with my
connection - it suddenly drops. I would then solve this by turning the modem
off and on.
US Robotics says the standard CD configuration may not be accurate to
Belgacom parameters so I may need to do a manual installation.

Belgacom can only give me these parameters arguing that the ones in their
shop only require these:
vpi=8
vci=35
encapsulation=llc or snap
Normally it's pppoe (ethernet), but pppoa is also possible.

While US Robotics can still give no further light on what to fill in on
these.
> Service category: USB without PCR
> Enable Quality Of Service: deselected
> PPPoe service name: empty
> Authentication method: Automatic
> MTU: 1492
> Dial on demand (with idle timeout timer) : deselected
> PPP IP extension: deselected
> IGMP multicast: selected
> WAN service: selected
> Service name: pppoe_8_35_1
> Allow "Reaim" proxy: selected

Does any of you have any ideas on what is the best parameters? or how to
solve this issue?
Thanks.

[albatros]

"XYZ" <nospam@nospam.com> schreef in bericht
news:44cdf527$0$32426$ba620e4c@news.skynet.be...
> Hi all,
> I bought a Wireless MAXg ADSL 9108 and a PC Card USR5411 to use for my
> Belgacom connection. But have been having great difficulties with my
> connection - it suddenly drops. I would then solve this by turning the
> modem
> off and on.
> US Robotics says the standard CD configuration may not be accurate to
> Belgacom parameters so I may need to do a manual installation.
>
> Belgacom can only give me these parameters arguing that the ones in their
> shop only require these:
> vpi=8
> vci=35
> encapsulation=llc or snap
> Normally it's pppoe (ethernet), but pppoa is also possible.
>
> While US Robotics can still give no further light on what to fill in on
> these.
> > Service category: USB without PCR
> > Enable Quality Of Service: deselected
>> PPPoe service name: empty
>> Authentication method: Automatic
>> MTU: 1492
>> Dial on demand (with idle timeout timer) : deselected
>> PPP IP extension: deselected
>> IGMP multicast: selected
>> WAN service: selected
>> Service name: pppoe_8_35_1
>> Allow "Reaim" proxy: selected
>
> Does any of you have any ideas on what is the best parameters? or how to
> solve this issue?
> Thanks.

I use US Robotic from the beginning.
Its always works fine.
Never had problems.

Look on this url,
http://www.usr.com/support/9108/9108-du-ug/index.htm


>
>
>